Installation Procedure
17
Connect power pigtail for ERP48-FT
A spiral wrapped cable is hard wired to the transformer in the top panel of the and ERP48-FT
and connects to the transformer in the lower panel. This connection is made at the factory
prior to shipment of standard 48 Relay Panels.
When non-standard ERP48-FT units are shipped from the factory this connection must be
completed by the installing contractor. The power pigtail is hard wired to the transformer in
the top panel. Reference the graphic below for indication of cable routing and connection of
the free end of the power pigtail.
Feed the free end
of the power
pigtail through the
plenum area.
AC Input
120V, 230V or 277V
AC 50/60Hz
Pull the power
pigtail through
the plenum area
to the lower
transformer.
Front View - covers removed
Right Side - cutout
Connect the
Mate-N-Lok™
connector to the
receptacle.
