Installation Procedure
13
Chapter 2
Installation Procedure
Install Mounting Hardware
Step 1:
Remove the front cover(s) with locking doors to reveal the relay panel interior.
Step 2:
Hold the Relay Panel to the desired mounting location.
Step 3:
Mark the keyhole locations on the wall with a pencil.
• ERP-FT 24 panels can install up to two-high by any width.
• ERP-FT 48 panels are 44cm (17.35”) wide by 120.1cm (47.3”) high, including
removable panels and screws.
Allow clearances as described on
.
Step 4:
Once all marks have been made, set the Relay Panel aside.
Step 5:
Install the required hardware for mounting the enclosure using the previously marked
reference points as a guide.
•
ERP24-FT
requires four 6-8mm (1/4” - 3/8”) bolts or screws,
50-100mm (2-4”) long and suitable wall plugs.
- Both the surface and mounting hardware must support 22.68kg (50lbs).
- Expose at least 25mm (1”) of threads for mounting the Relay Panel.
15.5”
(394mm)
15.5”
(394mm)
17.35”
(441mm)
26.25”
(667mm)
19.5”
(495mm)
ERP24-FT24
ERP48-FT48
15.5”
(394mm)
17.35”
(441mm)
15.5”
(394mm)
15.5”
(394mm)
47.3”
(120.1cm)
