E T C I n s t a l l a t i o n G u i d e
SmartClick Switch Station
SmartClick Switch Station
Page 4 of 4
Step 3: Do one of the following:
• If using double-sided tape, remove the protective film to reveal the
sticky surface.
• If using Velcro, attach the opposite Velcro material to its mating
strips and then remove the protective film to reveal the adhesive.
Step 4: Press the station into place.
Step 5: Attach the faceplate (not included).
Flush Mount in a Back Box
Step 1: Insert the station into the back box.
Step 2: Secure with two screws (hardware provided by others).
Step 3: Attach the faceplate (not included).
Linking to a Controller
After the SmartClick Switch Station has been installed, it must be linked to the
Aero controller. Refer to the
Unison Aero 902 MHz User Programming Guide
for linking and programming instructions. ETC documentation is available for
free download at
www.etcconnect.com
.
N o t e :
If line voltage wiring is installed in the back box, proper
voltage barrier is required between the wiring and the back
box.
When equipped with 902MHz radio -
Contains FCC ID: SZV-PTM210U and contains IC: 5713A-PTM210U
When equipped with 315MHz radio -
Contains FCC ID: SZV-PTM200C and contains IC: 5713A-PTM200C
The enclosed device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(I.) this device may not cause harmful interference and
(ii.) this device must accept any interference received, including
interference that may cause undesired operation.