10
Source Four Zoom CE User Manual
English
Setting the angle within the moveable yoke
Step 1:
Loosen the moveable yoke’s locking knobs. Do not remove them.
Step 2:
Tilt the luminaire to the desired position as shown in
Figure 13
.
Step 3:
Tighten the yoke’s locking knobs to secure the luminaire in position.
Cleaning lens and reflector
Cleaning glass lens
Replace lenses if they contain visible damage (cracks or deep scratches) that may impair their
effectiveness.
Step 1:
Rotate the extrusion door fastener 1/4 turn to the right or left and open extrusion door.
Step 2:
Set the lens to the narrowest field angle to maximize the distance between the lenses.
Step 3:
Remove dust with a blast of oil-free air or wipe with a clean, lint-free cloth. Isopropyl
alcohol, distilled water or a 50%-50% mixture of each can be used to clean the glass
surface.
Step 4:
Starting from the center, gently wipe the lens.
Step 5:
Close the extrusion door and turn the fastener 1/4 turn to secure it.
W A R N I N G :
Do not use ammonia-based or other harsh commercial cleaners. Clean lens
and reflector only as directed.
Commercially available glass cleaning agents should be avoided as they
may contain ammonia, other harsh chemical detergents or abrasive agents.
These cleaners may damage the glass surface and the Anti-Reflective
coatings. Do not immerse or soak the glass in any cleaning solution.
N o t e :
To clean the 15°-30° Zoom, rotate the lens tube to its limit in one direction
(approximately 25°) so the extrusion door will clear the balance yoke. See
Figure 14
.
Figure 13
Yoke locking knob
Horizontal mounting
Vertical mounting
Turn to
the left
or right
Figure 14
Extrusion door
Summary of Contents for Source Four Zoom CE
Page 14: ...12 Source Four Zoom CE User Manual English...
Page 15: ...13 English...
