Operation
9
Onboard User Interface
You can control the operation of the SealerAtor through the onboard user interface, which
consists of a display and navigational controls.
1. Press the [MODE/ESC] button
Mode
Esc.
to access the main menu
2. Browse the menu by pressing the up, down, left, or right navigation buttons, and press the
Enter button
to select a menu item.
3. Modify the selection by pressing the up, down, left, or right navigation buttons according
to the selection.
4. Press the Enter button
to confirm a selection.
5. To exit the menu or selection, press the [MODE/ESC]
Mode
Esc.
button.
Menus
The content of the user interface is organized into several menus.
Test Menu
Access the Test menu to perform vacuum and pressure tests on a fixture.
Perform an Auto Test
Note:
See
to select the profile of the fixture you intend
to test.
Navigate: Main Menu
→
Test
→
Auto
The Auto test automatically performs both the pressure and vacuum tests.
•
Start Test starts the test.
•
Back returns to the Test menu.
After you select Start Test, you must specify the serial number of the fixture to be tested in
order to complete the test. Use the up, down, left, and right navigation buttons to enter the
serial number when prompted. The serial number is located on the bottom of the fixture upper
enclosure.
Test results for Auto tests that pass are saved to the microSD card. See
for information about retrieving the results.
Note:
If the test fails, contact ETC Technical Support for assistance.
