16
Source Four LED Series 3 User Manual
Use Fixture in Stand-alone Mode
After you connect power to the fixture, press the Function button (
), use the Intensity encoder
to navigate to one of the following stand-alone modes, and then press the Intensity encoder to
select it:
•
Studio: Use one of three studio (white light) presets, or customize the presets.
•
Color: Use one of 12 color presets, or customize the presets.
•
Effects: Use a sequence, or customize a sequence.
•
Preset: Use one of 12 presets (color fade time), or customize the presets.
The colors of options on the display correspond to the colors of the encoders below the display
and the Intensity encoder to the right of the display. Turn an encoder to modify the
corresponding value on the display, or press an encoder to activate the corresponding option at
the bottom of the display. Press the Intensity encoder to toggle between the current intensity
and 0%.
If the fixture is connected to other Source Four LED Series 3 fixtures that are in the same stand-
alone mode, the connected fixtures will play the same preset or effect.
Note:
If the colors on the display or on the encoders are difficult to discern, you can
navigate based on position rather than color:
•
Intensity = Intensity encoder
•
From top to bottom (in main section of display):
-
Top value = Left encoder
-
Middle value = Center encoder
-
Bottom value = Right encoder
•
From left to right (at bottom of display):
-
Left value = Left encoder
-
Center value = Center encoder
-
Right value = Right encoder