ETC PENKO Flex, Manual, Page: 7 / 16

September 1, 2011
WEIGHT CONTROLLER TYPE FLEX CHECK/CATCH
WEIGHER
ETC | First use of the indicator. 7
First use of the indicator.
Before using the controller, please setup the internal indicator first.
Login first to enter the System settings,
Default no password is selected.
The overall password is “25630”.
Set the display stepsize in the
indicator format menu.
Set the point position in the
indicator format menu.
Enter the System settings.
Delete previous calibration
points.
Calibrate the zero point
(deadload)
In the calibration menu
Calibrate a gain point
(Reference weight)
In the calibration menu
The step size defines the scaled parts of the weight value.
The display value will be round off to the nearest value with a
valid step size.
Step size can be set at 1, 2, 5, 10, 20, 50, 100, 200, 500, 1000,
2000 or 5000.
The Decimal point defines the point position of the weight value.
Decimal point position can be set from NONE to 0,00000.
All previous calibration points should first be deleted before
making a new calibration.
When all points are deleted, first calibrate the Dead load (0).
Make sure the scale is completely empty and type 0 in the
“Add/Replace” field by pressing the
“Edit” button.
To save the zero point press the “+ Activate” button.
The Dead load is calibrated now.
To calibrate the gain weight put a reference weight on the
scale.
Press the
“Edit” button to type the exact reference weight in the
“Add/Replace” field.
To save the reference weight, press the “ + activate button”.
The reference weight is calibrated now.
Set the maximum display
value of the indicator
To prevent overload by the user, the FLEX will not show any
weight above this value.
In certified mode the max load is not allowed to be more then
the maximum load + 9 scale parts.