ETC Installation Guide
P-NSPS-D
Configuration
When the Network Station Power Supply is connected to the P-ACP, the
display will show the assigned IP address. An error will display in the Status
screen when the P-NSPS-D is not connected, has never connected, or the
communications to a P-ACP are interrupted. See
for
more information.
Processor assignment and
are accomplished using Paradigm
LightDesigner configuration software. Reference the Paradigm LightDesigner
online help system for details.
Preferences
Preferences for the Network Station Power Supply, such as inactivity time, are
set in the LightDesigner configuration file and sent to the power supply when
the P-ACP establishes communication.
Remove P-NSPS-D from DIN rail
If for any reason you need to remove the Network Station Power Supply from
the DIN rail, follow these instructions.
1. Turn off power (at the source) to the 48 VDC Power Supply.
2. Disconnect all wiring to the P-NSPS-D.
3. Grip the P-NSPS-D and in one motion, slide it straight up and pivot the
top of the unit off of the DIN rail.
P-NSPS-D
Page 7 of 8
ETC
