Irideon WLZ User Manual
15
Install Portable Fixture on Unistrut Track
Spacer
Washers
Yoke
bolt
You can install the portable fixture
on Unistrut track using the Irideon
FPZ Unistrut Kit (7191K1000).
1. Insert the spacer into the
driver box through the hole
in the top of the yoke.
2. Use the yoke bolt and
washers to fasten the fixture
to the Unistrut track.
Within the EU, use an M12
bolt and appropriate washers
in place of the provided kit
hardware.
Connect Cables to
Portable Fixture
1. Connect RJ45 data cables to the top of the driver box, one for data
in and one for data thru (in either position), as needed.
•
To order RJ45-to-socket XLR adapter, use part number W6538.
•
To order RJ45-to-plug XLR adapter, use part number W6539.
2. Connect the fixture to the power source.
Note:
•
The Irideon WLZ is not self-terminating. You must terminate
the last fixture in line with a 120 Ohm resistor. Please
contact your ETC customer service representative to
purchase part number N4086.
•
No more than 32 DMX devices can be daisy-chained
together on a single run. For runs of fixtures totaling more
than 32 DMX devices, use a DMX splitter to split the DMX
runs.
•
When using DMX over Cat5, use Cat5e or better. Cable
distance must not exceed 300 m (1000 ft).
•
The Irideon WLZ cannot be controlled via network protocols
and should not be connected to a system network.
