ETC Element Classic, User Manual

Page: 424 / 687

410 Ion Classic User Manual
Execute List
The execute list for submasters can be used to trigger actions such as macros, snapshots, MIDI
Raw, Serial Strings, and cues. This works similar to the External Links for cues.
There is an {Execute} softkey that is available after you press the [Sub] button in either Live,
Blind, or the sub list display.
When you press {Execute}, the softkeys will change to {String}, {Macro}, {Relay}, {On}, {Off},
{Snapshot}, and {MIDI Raw}.
Note:
Macros can also be assigned as a button action. See Submaster Fader and
Button Configuration (on page 407)
Triggering an Action
Pressing the bump button of a submaster will trigger any actions assigned to its execute list.
Adding a Trigger
•
[Sub] [1] {Execute} {Macro} [2] [Enter] - triggers macro 2 when submaster 1's bump
button is pressed.
Removing a Trigger
•
[Sub] [1] {Execute} {Macro} [Enter] - removes the trigger from submaster 1's execute list.
[Freeze] and [Stop Effect] on Submasters
[Freeze]
[Fader Controls] {Freeze} can be used to halt all effect activity on any active submaster. To
activate a freeze for only a specific submaster, press [Fader Controls] {Freeze} & [Load].
There are two ways to remove the freeze command:
•
Press {Freeze} & [Load] again for the specific faders to unfreeze the activity.
•
Press [Assert] & [Load] or [Go] or [Stop/Back] for the specific faders to resume the
activity.
[Stop Effect]
The [Fader Control] {Stop Effect} button can be used to stop all effects from operating on any
or all faders, or it may be used with the control keypad to stop a specific effect.
•
To stop all effects on a fader, press [Fader Control] {Stop Effect} & [Load] of the
associated fader.
•
To stop a specific effect regardless of the fader it is operating on, press [Effect] [2]
[Fader Control] {StopEffect} [Enter].
When an effect is stopped, all impact of the effect is removed and the stage output is as
though the effect had never been activated.
Moving and Copying Submasters
You can move a submaster using Move To. Press [Copy To] twice to put Move To on the
command line.