3
i
Note:
When a button is pressed and a single Red LED blinks, it is
an indication that the RPS telegram was transmitted but the
battery voltage is low (less than 2.2V).
When the Red LED blinks 3 times on a button press the RPS
telegram was not transmitted and the battery is critically low
(less than 2.0 V)
A stuck button will cause a repeating red blink roughly every 5
seconds
Test Modes
1. To access tests, remove the faceplate and press the button on the side of the
unit using a fingernail, pen or small tool.
2. Press and hold the side button until all LEDs blink (about 5 seconds)
3. Tap the button to scroll through the selections. (see table below)
4. To select an item, press and hold the button until all the LEDs blink (about 5
seconds)
Test mode times out after 180 seconds.
Test Menu
Single red blink
REBOOT device
Single yellow blink
Range Confirmation
Single green blink
Reserved for future use
Single green + red blink
DEBUG: Test button pad
Single green + yellow blink
DEBUG: Transmit CM APP Version
Reboot
When rebooted, a successful switch start up is indicated by a light chase sequence:
green -> yellow -> red repeated three times.
A weak battery will cause a repeating red blink roughly every half second.
A stuck button will cause a repeating red blink roughly every 5 seconds
Range Confirmation
Provides visual feedback of the MBI’s signal strength received by a linked Echoflex
controller.
i
Note:
•
Disable all repeaters in range
•
The station should only be linked to one controller
when running the test
1. To enter Range Confirmation Test press and hold the side button until all LEDs
blink (about 5 seconds)
2. Tap the button to scroll through the selections. When the yellow LED is
blinking, press and hold the side button until all the LEDs blink (about 5
seconds)
All three LED’s will blink on and off quickly for a second followed by a pause, then
repeats. When the sensor receives a range confirmation telegram from the linked
controller, the sensor displays the signal strength status for 2 seconds, see table
below.
LED - blinking Signal Strength
Status
Green
-41 to -70 dBm
Best
Yellow
-70 to -80 dBm
Good
Red
-80 to -95 dBm
Not ideal, try moving sensor closer
None
No linked controllers detected. Move sensor closer or add telegram repeating
The test will repeat every 10 seconds and run for a duration of 180 seconds.
