ETC E-OCC, Installation Manual

Page: 8 / 12

Echoflex Installation Guide
Occupancy Sensor
DIP Switch Settings
DIP switches on the sensor electronics provide for additional configuration
options including Use Custom Config, Vacancy Timeout, Enable/Disable PIR
detection LED, and the ability to restore the sensor to its factory defaults.
Switch # Use
1 Unused (leave Off)
2 Enable/Disable Custom Config Mode
•
When “Custom Config” is set to Off (also known as Basic
configuration mode), local DIP switch settings for Vacancy
Timeout and Enable PIR LED are used. Sensor actions can
be adjusted using the program [MODE] button. This is
the default setting. See
Configuration on page 9 .
•
When “Custom Config” is set to On, all other local DIP
switch settings are ignored. Instead, the settings made by
the ElahoAccess App are used.
3 and 4 Vacancy Timeout
•
5 min = Switches 3 and 4 are Off
•
15 min = Switch 3 is Off and Switch 4 is On (default)
•
30 min = Switch 3 is On and Switch 4 is Off
•
Auto = Both switches are On (See Vacancy Timeout on
page 10 .)
5 PIR Detection LED
•
When set to On (default), the occupancy detection LED
illuminates the lens when movement is detected.
•
When set to Off, the occupancy detection LED is disabled
unless the unit is in Walk Test mode.
6
Unused (leave Off)
7 Unused (leave Off)
8
Restore to Defaults at boot
•
When set to On and power is cycled to the sensor, the
unit restores to its factory default settings.
•
Off is the default setting.
Occupancy Sensor Page 8 of 12 Echoflex