ETC Installation Guide
ColorSource Spot jr v2.0/v3.0
Accessories
You can use standard accessories, such as a gobo, in the accessory slot (see
image above). You can also attach an accessory holder to the front of the
fixture (order part number 7416K1001). After you attach the accessory holder,
you can use it to secure accessories such as a top hat or half hat. See the
ColorSource Spot jr datasheet at
for accessory information.
You can attach a ColorSource Relay to the yoke. See
for more
information about ColorSource Relay.
Set the DMX Address
1. Press any button to wake the display. The display shows the DMX
address.
2. Use the Up and Down buttons to select the DMX address for the fixture.
You can also use RDM for DMX addressing. See
Change the DMX Control Mode
You can set the DMX control mode for the fixture to one of four available
mode options.
1. Press any button to wake the display. The display shows the DMX
address.
2. Press and hold the Mode button for 3 seconds. The display shows the
current DMX control mode.
3. Press the Up button or Down button to change the DMX control mode.
•
5ch
: 5-channel mode (intensity, red, green, blue, and strobe). This is
the default mode.
•
dir
: Direct emitter control (intensity, red, green, blue, indigo, lime, and
strobe).
•
1ch
: 1-channel mode controls the intensity of preset 1 (defaults to
3200 K White).
•
rgb
: RGB mode (red, green, and blue).
4. Press the Mode button to confirm your selection.
The display will automatically return to the DMX address after 10 seconds of
inactivity, and edits to the DMX control mode will not be saved. This cancels
unsaved changes.
ColorSource Spot jr
Page 6 of 16
ETC
