PhaseAdept Dimmer
69
Features
Input Voltage
Supported Load Types
• LED
• Tungsten
• 2-wire fluorescent
• Electronic low voltage transformer
Short Circuit Protection
In the event of a short circuit, the PhaseAdept Dimmer module shuts down to prevent damage. The
module allows inrush current shown below for one cycle and will shut down if current at the inrush
current threshold persists for more than one cycle or if current exceeds the inrush current threshold.
Inrush Protection
Voltage Spike Protection
The module shuts down in the presence of voltage spikes caused by a magnetic load. To recover from
this shutdown state, turn the circuit breaker off and back on again, change the phase switch to
forward (see
Forward/Reverse Phase Switches
), or set the control level to zero and then set
the control level to another value.
Curve
The PhaseAdept Dimmer outputs a linear curve that is scaled according to the minimum scale dial
setting. See
.
Nominal
Voltage
Operating
Voltage Range
Operating
Frequency Range
100 V
90–135 VAC
47–63 Hz
120 V
230 V
207–253 VAC
240 V (Delta)
277 V
249–305 VAC
Note:
ETC does not support the use of the PhaseAdept module with magnetic loads.
Module Name
Part Number
Inrush Current
LED10
7050A1296
100 A
LED10NJ
7050A1297
100 A
LED10RJ
7050A1298
100 A
ELED6
7070A1426
60 A
ELED6N
7070A1428
60 A
ELED6R
7070A1427
60 A
HLED6D2
7070A1429
60 A
LED10
7183A1209
50 A
ALED5
7183A1210
100 A
