Etatron America WATER METER SIGNAL SPLITTER, Operatinginstructions And Maintenance, Page: 5 / 12

ENGLISH
5
•
In the event of damage to the equipment power cable, ask for it to be replaced by our service centers or qualified
personnel to prevent risks for the people who use it;
EXPLOSION HAZARD :
•
This equipment is not explosion-proof. Do NOT install and do NOT use in an explosive or potentially explosive
environment.
Shipping to the factory for repairs and/or maintenance
The material to be sent to the factory for maintenance should be disassembled and packed carefully; all the parts in
contact with the chemical must be emptied and rinsed to ensure the safety of the operators while transporting and handling
the material in the laboratory. In the event of failure to comply with the instructions given, we reserve the right to reject the
equipment and to return it at your expense; damage caused by the chemical to the material will be included in the repair
estimate.
GENERAL REGULATION
Proper use of the equipment
The equipment must only be used for the purpose which it was expressively manufactured, i.e to dose liquids. Any
other use is considered improper and therefore dangerous. The equipment is not foreseen for use in any applications not
taken into consideration during the design stage. For further clarifications, the customer must contact our offices where the
user will receive information about the type of the equipment in his possession and its correct use. The manufacturer cannot
be considered responsible for any damage derived from improper, erroneous and unreasonable use.
Shipping and handling
Shipping must be performed in the same orientation as indicated on the packaging. Shipping using any means, even if
delivered free to the customer, is considered at the purchaser’ s risk. Claims for missing material must be made within 10
days from goods receipt. Claims for defective material must be made within 30 days from goods receipt. Restituition of
equipments must be agreed beforehand with authorized personnel or with the authorized distributor.
Assembly
All the equipments we produce are normally supplied fully assembled. For better clarification, consult the appendix at
the end of this manual where exploded assembly drawings and views of the equipments are available together with all
components and their nomenclature, for the user to have complete details of the equipment components. These drawings
are indispensable when searching for malfunctioning or defective parts.
Dismantlement
To dismantle the equipment or before performing equipment maintenance, proceed as follows:
•
Make sure the equipment is electrically deactivated (both poles) by disconnecting the conductors from the
power supply using the omnipolar switch which must have a minimum distance of 3mm between its contacts.
Please pay particular attention to this last point and we recommend the user to consult the enclosed drawings and
chapter “ RISKS ” before starting any operations.
Warranty
2 years. For warranty contact ETATRON AMERICA.