Pin CON2
Signal
Description
1
U
Batt
Battery Supply Voltage for XETK
2
GND
Ground
XETK-V2.0 - User’s Guide
24
ETAS
Hardware Description
Additionally the through-hole solder pad CON3 can be used to connect a power
supply U
Batt2
. The power supply on CON3 must use the GND of CON2.
`lkO
`lkP
Fig. 4-9
Power Supply Connectors CON2 and CON3
4.5
XETK Ethernet Interface
The XETK Ethernet interface shown in Fig. 4-10 can be directly connected to the
PC. No additional ETAS module is required for the access to the ECU.
The interface is a standard full duplex 100Base-TX Ethernet interface using the
XCP protocol. The XETK Ethernet interface is integrated in the ETAS IP world with
automatic IP management and supports the open automotive "Universal Mea-
surement and Calibration" standard "XCP on Ethernet" (TCP/IP, UDP/IP). The
open XCP on Ethernet interface allows for connecting to the XETK-V2.0 with
third party application software.
The XETK Ethernet interface is not compatible with the ETK interfaces in mod-
ules like e.g. ES910, ES590, ES591, ES592, ES593-D, ES595, ES1232-A.
The XETK Ethernet interface is compatible with the ECU interface of the ES910
module and the Ethernet interfaces of the ES51x/ ES592/ ES593-D/ ES595/
ES600 modules.
The maximum length of the interface cable is specified for 30 m.
Note