Hardware Configuration
17
4.2
Parameterizing the Hardware Configuration (HWC) in INCA
4.2.1
Automatic Hardware Configuration
It is recommend to have the Hardware Configuration generated automatically.
Use the menu
Hardware
→
Search for Hardware
for this operation.
It will be searched for connected hardware by interrogating all interfaces. All
hardware that is physically connected will be added to the hardware configu-
ration.
4.2.2
Manually Hardware Configuration
If you want to organize or change your Hardware Configuration manually, you
must note how the ETK Controller (ETKC) counts as well as observing the order
of installation in the ES1000.2/ES1000.3 system recommended above:
•
starting from the left, the ETK ports are referred to as ETKC-A through
ETKC-D. The system controller can operate a maximum of 4 ETK control-
lers,
•
the ETK ports are always numbered consecutively by the system controller,
•
this numbering has to be reflected exactly in the HWC.
The
ETK index
parameter can be selected accordingly in the Hardware Con-
figuration with the ETKC device.
The following tables show two configuration examples as specified in the
Hardware Configurations shown below (Fig. 4-2and Fig. 4-3).
The description of the ETK ports in the HWC has to correspond
exactly
to
where the hardware is installed.
ES1232_1-ug-en.book Seite 17 Freitag, 28. Januar 2005 12:14 12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
