VIII. TROUBLESHOOTING
Problem
Cause
Solution
Motor won‘t start
Power supply not connected
Check the cord, plug and the socket
ON/OFF
button is not switched on Push button
ON/OFF
Lid cannot be
closed - safety
lock activated
Incorrectly fitted fixture with the
dustbag
Check / repair the position of the
dustbag and its fixture
Suction output is
not sufficient
Regulation in MIN position
Set regulation to MAX.
Full dustbag
Replace the dustbag
Foul filtration system
Clean or replace the input and
output filters
Nozzle, suction hose or tube is clogged Remove blocking objects
The remote
control does not
work
The batteries are flat or
incorrectly fitted (or not fitted at
all)
Insert charged batteries into the
remote control
The vacuum cleaner was not
switched
ON
by the
ON
/
OFF
switch situated on the vacuum
cleaner
Switch
ON
the vacuum cleaner by
the
ON
/
OFF
switch situated on the
vacuum cleaner
The remote control is not paired
with the vacuum cleaner.
Switch on the vacuum cleaner.
Press buttons
B3
and
B4
simultaneously for about 3 seconds.
Suction power symbols will start
flashing in turns. Press the button
D1
on the remote control and switch
the vacuum cleaner over to the
standby mode. The remote control
is now paired with the vacuum
cleaner and ready to use.
The cable cannot
be wound in the
entire length
Twisted cable
Straighten the cable
Take out about 50 cm of the cable
and push again button
If you are unable to fix the problem, or if you need any further information about the
appliance or service centres, please contact your distributor.
Replacement of parts that require intervention in the electric part of the appliance
must be carried out by a specialized service! Failure to comply with the instructions
of the manufacturer will lead to expiration of the right to guarantee repair!
GB
34 / 57
