–
Pull the separator
B6
out of the container by grabbing it by the protrusions on its top part.
When putting the separator back, make sure the protrusion clicks back precisely into the
cut-out on the edge of the container
B
, see pic. 12C.
–
Take down the separator matrix
B8
from the separator (turning it counter-clockwise and
sliding out), see pic. 12D.
– As the last part, take out the separator cover
B7
by sliding it upward. When putting it back,
make sure the long cut-out on the cover of the separator clicked into the long protrusion on
the separator
B6
, see pic. 12E
Outlet microfilter
Press the closure in the top part of the exhaust cover
A9
, fold the cover up and remove
from the cleaner (pic. 13). Pull out the microfilter
A8
. Put the properly cleaned (or new)
microfilter back into the cover reversely. Put the protrusions on the back cover into two
openings in the casing of the cleaner and close the cover with a click.
Clean all accessories
B
(i.e.
container, separator and its parts, textile microfilter
), the
exhaust microfilter
A8
and grid
A10
in lukewarm running water with a cloth or a fine brush
and let dry thoroughly. When all the parts have dried completely, assemble them back
reversely.
ATTENTION
– Do not use any aggressive washing or cleaning agents or hot water to clean the micro-filters.
– Cleaning the filter will not restore its original colour, but it will restore its filtration properties.
– The dust container is not resistant to cleaning in a dishwasher.
– The micro-filters are not intended for cleaning in a dishwasher.
– Neglecting regular replacement of micro–filters can result in the vacuum cleaner defect!
– Make sure that the binding surfaces and sealing elements are functional.
– Replace the other filters if they cannot be cleaned properly or if they are damaged. You
can buy a spare micro-filters in the network of elektro shops.
!
Storing accessories
The floor nozzle, the suction tubes and the hose can be dismantled again or left assembled
and hung on the back side of the vacuum cleaner into the storage position (Fig. 14). For
better stability, slide individual parts of the tube to each other so that the tube is as short as
possible. When storing, always set the floor nozzle to the carpet position (i.e. with the brush
retracted); thus you will prevent bending of the bristles.
V. MAINTENANCE
Disconnect the appliance from the el. outlet. Store the vacuum cleaner at a dry place, far
enough from heat sources (e.g.
fireplace, stove, heating element
) and protect it from
weather conditions (e.g.
rain, sunshine
). Treat surface of the appliance with a soft and damp
cloth, do not use coarse and aggressive detergents! Store the appliance properly cleaned at
a dry, dust-free place out of reach of children and incapacitated people.
Floor nozzle, brush
After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If there are some impurities, remove them.
23
GB
/ 39