Paper / synthetic filter:
pull out the dust filter lock
A16
from the guide ribs of the holder
A15
(Fig. 14) and dispose it with common municipal waste. Slide the
front part of the dust filter (in the direction of the arrow) to holder
A15
in the suction space of the vacuum cleaner and push it to the
maximum position.
UniBag:
hold adapter
B
and remove it from the guide ribs of holder
A15
by pulling it
(Fig. 14). By lifting off lock stop
B1
, dust filter
A16
will be released from the holder/
adapter (Fig. 15). Dispose of the dust filter with common municipal waste. Slide the
projections on the front of a new dust filter into the holes in adapter
B
and secure
the front by slight pushing. You will hear a clicking sound.
Check proper fastening of the front by slight pulling of the dust filter. Slide the adapter with
a filter to the holder in the suction space and push it to the maximum position. Close the
vacuum cleaner lid by snapping it shut. You will hear a clicking sound.
Note
–
Proper fixing of the cardboard front of a dust filter to the holder / adapter and proper
sliding of the holder with the filter to suction space of the vacuum cleaner will result in
releasing mechanical safety lock that will make it possible to close vacuum cleaner lid
A2
.
– Safety lock does not enable closing the vacuum cleaner lid if you forget to insert a dust
filter (paper, synthetic or textile).
i
Replacing micro-filters
After replacing about 5 dust filters, micro-filters must be cleaned or replaced with new ones.
Dispose of the used dust filter and the micro-filters with common municipal waste. You can
buy replacement filters and micro-filters in electro store chain.
Suction micro-filter
Take out grid
A8
with filter
A17
by pulling it upwards (Fig. 16). Remove the filter from the grid
(Fig. 17) and clean it in running lukewarm water, e.g. using a cloth or a soft brush and let it dry
completely (Fig. 19). After drying, put the grid with a new micro-filter in the opposite direction
behind the guide ribs and slide it to the suction area of the vacuum cleaner to the maximum
position.
ATTeNTION
– The „UniBag” dust filter is not intended for repeated use.
– DO NOT THROW THE ADAPTER AWAY!
– Do not use any aggressive washing or cleaning agents or hot water to clean the HEPA filter
and the micro-filter.
– Cleaning the filter will not restore its original colour, but it will restore its filtration properties.
– The HEPA filter and the micro-filters are not intended for cleaning in a dishwasher.
– Neglecting regular replacement of micro-filters can result in the vacuum cleaner failure!
– Make sure that the contact surfaces and sealing elements are functional.
– We recommend replacing the HEPA filter twice a year. Replace the other micro-filters if they
cannot be cleaned properly or if they are damaged. You can buy a replacement dust filter,
a HEPA filter and a micro-filter in the elektro shop chain.
!
exhaust micro-filter
Take out exhaust grid
A12
from the vacuum cleaner by pulling it upwards (Fig. 18). Take out
foam filters
A13
from the grid and remove Tap the dust out of the filter over a dustbin or to clean
the filter through a blowing (we recommend the filter cleaning outside of living area for hygiene
reasons).
28
GB
/ 48
