eta CANTO, Instructions For Use Manual

Page: 22 / 44

II. EQUIPMENT AND ACCESSORIES
A – vacuum cleaner
A1 – suction vent A10 – power cord
A2 – lid A11 – parking holes
A3 – lid lock A12 – exhaust grid
A4 – START/STOP button A13 – foam micro-filter
A5 – power cord winding button A14 – exhaust HEPA micro-filter
A6 – electric motor regulation A15 – filter (adapter) holder
A7 – full filter signaling A16 – dust filter
A8 – cover (grid) A17 – suction micro-filter
A9 – handle
B – adapter for UniBag (not included)
B1 – filter head blocking lock
C – accessories
C1 – floor nozzle C5 – brush
C2 – suction hose C6 – crevice nozzle
C3 – suction tube C7 – parquet nozzle
C4 – upholstery nozzle
III. VACUUM CLEANER PREPARATION
Hose
– Connect hose C2 to the vacuum cleaner by inserting the end piece to suction vent A1 to
the maximum position (Fig. 4). You will hear a clicking sound.
– Disconnect the hose by pressing the button on the end piece and remove the hose by
pulling it slightly.
Telescopic tube
– You can connect tube C3 with hose handle C2 by slight pushing the handle to the tube
(Fig. 3).
– You can disconnect the tube by pulling the handle slightly out of the tube.
– The telescopic tube allows setting suitable length to fit your figure. Press the lock pin in
the direction of the arrow and pull out or push in the required length of the tube (Fig. 5).
When you release the lock projection, the tube length is fixed. When pulling out, keep the
tube in safe distance from your face as the tube is very long.
Floor nozzle / parquet nozzle
– Connect and disconnect the accessories ( C1 , C7 ) in the same way as the tube (Fig. 2).
Floor / crevice nozzle / brush
– Connect and disconnect the accessories (
C4
,
C5
,
C6
) in the same way as the tube
(Fig. 3).
You can connect the appliance directly to the hose handle or to the telescopic tube.
22
GB
/ 40