eta 239490001E, Instructions For Use Manual

Page: 115 / 164

EN
EN - 115
SYPHON CONNECTION
• The waste connection must be at a height of max.100 cm
from the bottom of the dish.
• The water drain hose should be fixed by a hose clip.
Start of dishwasher
The followings should be checked before starting the
dishwasher.
1. Whether the dishwasher is level and fixed
2. Whether the inlet valve is opened
3. Whether there is leakage at the connections of the conducts
4. Whether the wires are tightly connected
5. Whether the power is switched on
6. Whether the inlet and drain hoses are knotted
7. All packing materials and printings should be taken out from the dishwasher
ATTENTION!
After installation, please put this manual into the bags of printings.
The content of this manual is very helpful to the users.
IX. TROBLESHOOTING TIPS
Before Calling for Service
Review the charts on the following pages may make you be free of calling for service.
Problem Possible Causes What To Do
Dishwasher
doesn‘t start
Fuse blown, or the circuit
breaker acted
Replace fuse or reset circuit breaker.
Remove any other appliances sharing the
same circuit with the dishwasher
Power supply is not turned on
Make sure the dishwasher is turned on
and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Water pressure is low
Check that the water supply is connected
properly and the water is turned on.
Door of dishwasher not
properly closed.
Make sure to close the door properly and
latch it.
Water not
pumped
form dishwasher
Kink in drain hose Check drain hose.
Filter clogged
Check coarse the filter
(see section titled “Cleaning The Filter“)
Kitchen sink clogged
Check the kitchen sink to make sure
it is draining well. If the problem is the
kitchen sink not draining ,you may need
a plumber rather than a serviceman for
dishwashers