eta 1493 90010, Instructions For Use Manual, Page: 24 / 60

Floor nozzle / TURBO nozzle / narrow TURBO nozzle
– Connect and disconnect the accessories ( C1, C8, C9 ) in the same way as the tube
(Fig. 2).
Upholstery, crevice nozzle, joint brush, DermoPet nozzle
– Connect and disconnect the accessories ( C4 , C6 , C5, D ) in the same way as the tube
(Fig. 3).
IV. USING THE VACUUM CLEANER
Remove all the packing material, take out the vacuum cleaner and the accessories.
Pull out the necessary length of power cord
A7
and plug the power cord into a socket.
Assemble the vacuum cleaner accessories
C1
,
C2
,
C3
(Fig. 2, 3, 4). If the cleaner is fitted
with telescopic tube C3 , adjust its length to fit your figure (Fig. 5). Floor nozzle C1
is designed to be used to clean carpets or smooth flooring (Fig. 6). If the floor nozzle is
fitted with the brush, pull it out by switching the flap when vacuuming hard floorings. You
can use crevice nozzle C6 for vacuuming places that are hard to access (Fig. 7). Narrow
TURBO nozzle C9 or upholstery nozzle C4 or brush C5 can be used to clean various types
of furniture (Fig. 8, 9). Adapter DermoPet D is intended for pet care. The vacuum cleaner
can be switched on or off by pushing button A2 marked with the symbol „ „ (Fig. 10).
The suction power can be adjusted by the control on hose handle C2 (Fig. 11) or by setting
control A5 (Fig. 10). The minimum suction power is recommended for fine fabrics
(e.g. curtains, drapes). The maximum suction power is recommended for floor coverings
(e.g. heavy-duty carpets). After finishing work, switch off the vacuum cleaner and unplug
it from the power supply. By pressing button A3 with the symbol „ “ (Fig. 10), the power
cord is wound automatically. The vacuum cleaner can be held and carried by handle A8 .
Full dust container indicator
If the coloured field is displayed permanently on indicator A4 while the floor nozzle is lifted
above the cleaned surface at maximum suction power (Fig. 12), the dust container must
be emptied. Disregard changes on the indicator during vacuuming.
Emptying the dust container
Press container lock button A6 and then remove container B from the vacuum cleaner (Fig.
13). Put the container above a dust bit and press button B2 ; thus you will lift off bottom B3
and throw the dust in common municipal waste (Fig. 14). Snap the bottom shut to secure
it and insert the container into the vacuum cleaner in the opposite direction.
For sanitary reasons we recommend emptying the container outside housing premises.
Cleaning the dust container, micro-filter and HEPA filter
After about 5 emptying of the container we recommend complete cleaning of the filtration
system to remove the settled dust.
- B6 separator: push button B2 , thus you will lift off bottom B3 , and you can release the
separator by turning it towards the UNLOCK sign, and then take it out
by pulling (Fig. 15).
- Foam micro-filter B4 : pull it out of the container (Fig. 16).
- HEPA filter B5 : pull it out of the container (Fig. 16). Tap the dust out of the filter over
a dustbin or to clean the filter through a blowing (we recommend the filter
cleaning outside of living area for hygiene reasons).
GB
24 / 53