eta 1493/10 ANDARE ANIMAL, Instructions For Use Manual, Page: 23 / 48

– The manufacturer is not responsible for damage caused by improper use of the appliance
and the accessories and its guarantee for the appliance does not apply in situations when
the safety warnings above are not complied with. Failure to replace or maintain all filters
regularly according to the instructions in Chapter IV. USING VACUUM CLEANER and also
using non–original filters, the properties of which resulted in failure or damage of the vacuum
cleaner is also understood to be improper use of the appliance.
II EQUIPMENT AND ACCESSORIES OF VACUUM CLEANER ETA – 1493/10
(Fig. 1a,b)
A – vacuum cleaner
A1 – suction vent A7 – power cord
A2 – START/STOP button A8 – holder
A3 – power cord winding button A9 – exhaust filter
A4 – full container indicator A10 – exhaust cover
A5 – electric motor regulation A11 – parking hole
A6 – container lock button
B – dust container
B1 – holder B4 – foam micro–filter
B2 – bottom lock button B5 – HEPA filter
B3 – bottom flap B6 – separator
C – accessories
C1 – floor nozzle C6 – crevice nozzle
C2 – suction hose C7 – accessories holder
C3 – suction tube C8 – TURBO nozzle
C4 – upholstery nozzle C9 – narrow TURBO nozzle
C5 – brush
D – DermoPet nozzle
D1 – articulated brush (suitable for the removal of the smallest impurities); can be used
with D2, D3, D4 extensions
D2 – brush (suitable for removing impurities from the short / fine hair, skin)
D3 – fine comb (suitable for removing impurities from the larger middle and long hair,
leather, top coat)
D4 – gross comb (suitable for removing impurities from the crude large / long / sharp hair, skin)
D5 – reduction
III. PREPARING THE VACUUM CLEANER
Hose
– Connect hose C2 to the vacuum cleaner by inserting the end piece to suction vent A1 to
the maximum position (Fig. 4). You will hear a clicking sound.
– Disconnect the hose by pressing the button on the end piece and pull the hose out slightly.
Telescopic tube
– You can connect tube C3 with hose handle C2 by slight pushing the handle to the tube
(Fig. 3).
– You can disconnect the tube by pulling the handle slightly out of the tube.
– The telescopic tube allows setting the suitable length according to your figure. Press the
lock pin in the direction of the arrow and pull out or push in the required length of the tube
(Fig. 5). When you release the lock pin, the tube length is fixed. When pulling out, keep the
tube in the safe distance from your face as the tube is very long.
GB
23 / 44