– Do not insert to or take the plug out of a socket with wet hands and do not pull the
power cord!
– The appliance is not intended for use in damp or wet environment and in
environment with the risk of fire or explosion.
– The appliance cannot be used in bathrooms in zones 0, 1 and 2 HD 384.3 S1!
It must not be used in close proximity of bathtubs, a shower or a swimming pool.
– The fan must not be used in premises where chemical substances, colours and other
flammable substances are used or stored.
– When handling the appliance, try to prevent injury.
– Use the appliance in the working position only at places with no risk of turning over and
in a sufficient distance from objects (such as
curtains, drapes, etc.
), heat sources
(e.g.
fireplace, heater, stove, cooker, radiators, hot air ovens, grills
) and wet
surfaces (e. g.
sinks, wash basins
).
– do not fix the fan on a wall or ceiling.
– do not switch on the fan if the appliance is not completely assembled or if the blade
wheel covers are damaged.
– Please check before every connection of the appliance to power supply whether the
switches on the control panel is in the off position and always disconnect the appliance
from power supply after use.
– For additional protection we recommend installation of current protection (RCd) with the
nominal release current not exceeding
30 mA
. Ask a control technician or an electrician
for advice.
– Never let air flow on you (or animals) for prolonged time.
– Use only original parts designed for this type.
– Holes for air ventilation must not be covered.
– Never put fingers or other objects into inlet and outlet holes of the fan.
– Make sure that impurities do not enter into the appliance (e.g.
clouds of dust, hair etc.
).
If impurities are sucked and settled inside the appliance, clean it (see par.
V. MAINTENANCE
).
– do not put the switched on fan on soft surfaces (e.g. on a
bed, towels, wipers, carpets
).
– Make sure that the power cord does not hang over the edge of the working table where
children could reach it.
– do not wind the power cord around the appliance; this will extend life of the power cord.
– If you need to use an extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
– Check the condition of the power cord of the appliance regularly.
– The power cord must not be damaged with sharp or hot objects, open fire; it must not be
sunk into water or bent over sharp edges.
– Never use the appliance for any other purpose than for that described in these
instructions for use!
– disconnect the appliance from the electricity after use.
– The producer is not responsible for damage caused by improper use of the appliance
(e.g.
injury, fire, etc.
) and its guarantee for the appliance does not apply to situations
when the safety warnings above are not complied with.
14
GB
/ 42
