ESWOOD OPERATING MANUAL CI-3B June 2011
8
I
NITIAL START
-
UP PROCEDURE
5
1.
The machine is shipped without water in the rinse cylinder and
with the thermostat set to 0
O
C. Check with your plumber that the
correct purge sequence has been carried out as per 7 & 8 of the
Installation instructions and that the thermostat has been set.
Note that the heating element must be safely covered with water
before the power is turned on.
Failure to observe the correct
procedure will cause damage to the element and is not
covered under warranty
2. Check that the water supplies have been turned on and turn the
power on. The red “Machine On” pilot light will illuminate and the
machine will begin to heat the water. It will take about 10-15
minutes for initial heating to 82
O
C in the rinse cylinder.
3.
Uncoil the clear 10mm diameter plastic hose tucked up under
the right hand side of the machine, and place the end into a bulk
container of commercial grade glass washing detergent. The
unit will prime itself after a few cycles.
Do not use wrong products as they will void the warranty, and
use
products
in
accordance with the manufacturers’
recommendations. Note that the CI-3B has the detergent pump
set up to handle undiluted detergent.
Do not dilute detergent.
4. When the “READY 82
O
C” light is on, press the Red button for an
all Hot cycle or Blue button for a Hot cycle followed by a Cooling
cycle. (the cooling cycle is only possible if Cold water has been
connected to the machine)
While the machine is running the amber “CYCLE ON” light is
illuminated.
Note that due to Health Regulations in some States, machines
in those States are fitted with a low temperature controller that
prevents the machine from starting until the wash/rinse water
has reached 82
O
C.
