6
I
NITIAL START
-
UP PROCEDURE
4
1.
With the rotary switch “OFF” turn the hot & cold water and power
on.
2.
Open the door, ensure the overflow tube is placed into the tank
drain flange and pump intake filter is located over the pump
suction hole (inside tank front) then close the door.
3.
The machine is fitted with an automatic detergent injector. Place
the free end of the 10mm clear plastic tube, located under the
machine, into a 4 Litre or other suitable container of detergent.
The unit will prime itself after the initial cycles.
The injector must not run without detergent. Do not use wrong
products as they will void the warranty, and use product in
accordance with manufacturers’ recommendations.
4.
Turn the rotary switch to “FILL” position (see page 7) and the
rinse cylinder will begin to fill with water. The fill light illuminates
till the cycle is complete. When the rinse cylinder is full, the
water will flow out of the rinse jets and fills the wash tank and
stop automatically.
This ensures that all air is expelled from the rinse cylinder and
that the heating elements are safely covered with water.
Failure
to observe the above will cause damage to the elements
and is not covered under warranty.
5. Open the door check that the wash tank is full. Place strainer
trays in position within the tank and close door. Turn the toggle
switch behind the lower panel (see photo, previous page) to the
“Run” position.
