CORRECTING DRIFT
It is normal for the Proto-X Vid to drift slightly. However, if it drifts
in any direction consistently press the trim button opposite the
movement as many times as needed to eliminate the drift.
LEFT TRIM
FORWARD TRIM
FORWARD TRIM
LEFT TRIM
RIGHT TRIM
BACKWARD TRIM
BACKWARD TRIM
RIGHT TRIM
TROUBLESHOOTING
PROBLEM:
Controller cannot be linked to the Proto-X Vid.
SOLUTION:
Throttle position needs to be at zero.
PROBLEM:
Controller LED fl ashing after linking.
SOLUTION:
Replace batteries.
© 2016 Estes-Cox Corp. A subsidiary of Hobbico, Inc.
4703-08 v1
REPLACEMENT BLADES
FRONT
Gray Blades, Blue LEDs
REAR
Black Blades, Red LEDs
Match the blade
to the motor.
CALIBRATING THE SENSORS
If the Proto-X Vid doesn’t trim well, recalibrate the sensors.
1.
Turn on the controller and the Proto-X Vid.
Place the Proto-X Vid on a fl at surface.
2.
Hold the left stick to the lower right. At
the same time, quickly move the right
stick left and right several times until
the blue LEDs fl ash.
90 DAY LIMITED WARRANTY
PLEASE DO NOT RETURN YOUR PRODUCT TO THE STORE
– Estes will repair
or replace factory defects for 90 days from the date of purchase. This warranty
specifi cally does not cover crash damage, misuse or abuse. To make a warranty
claim, please contact our product support team at 1-217-398-8970 or e-mail us at
[email protected]
If requested by Product Support, please send defective product to:
Hobby Services, 3002 N Apollo Dr., Suite #1, Champaign, IL 61822
This warranty applies only if the product is operated in compliance with the
instructions and warnings provided with each model. Estes assumes no liability
except for the exclusive remedy or repair of parts as specifi ed above. Estes shall
not be liable for consequential or incidental damages. Some states do not allow the
exclusion of consequential or incidental damages so the above exclusion may not
apply to you. This warranty gives you specifi c legal rights and you may also have
other rights which vary from state to state.
FCC STATEMENT AND INDUSTRY CANADA NOTICE:
1. This device complies with Part 15 of the FCC Rules and RSS-210 of Industry
Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Remark:
This device is in accordance with the digital device grade B limitation
and the 15th regulation of FCC. This limitation requires reasonable anti-interference
protection around the residence. The device can transmit radio wave during use and
can interrupt the mobile communication without proper installment. Interruption will
occur for special device. If the device do interrupt the radio or television, please turn
the device off then turn it on to adjust. Below are some resolution for your reference:
•
Move the receiving antenna
•
Enlarge the distance between the device and receiver
•
Try to not connect the device and the receiver on the same circuit
•
Ask for professional help from experts
3. This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of Industry Canada.
FCC ID: M45-46066
First, push the left stick. You will hear continuous beeps. Next, move
the right stick any direction and the Proto-X Vid will fl ip that direction.
PERFORMING AERIAL FLIPS
PUSH
HOW TO FLY
LEFT
ROTATE
LEFT
ROTATE
LEFT
ROTATE
RIGHT
ROTATE
RIGHT
LEFT
UP
FORWARD
FORWARD
BACKWARD
BACKWARD
UP
DOWN
DOWN
RIGHT
RIGHT
PROBLEM:
Proto-X Vid shaking.
SOLUTION:
Check if the canopy, chassis and blades are damaged. Replace if needed.
PROBLEM:
Will not take off.
SOLUTION:
Check that the blades are properly installed. Replace if needed.
The Proto-X Vid has three fl ight
modes. For gentle control, use
the easy mode, for increased
agility, use medium or expert.
MODE
BEEPS
LED
EASY
Solid Green
1
MEDIUM
Flash Green
2
EXPERT
Flash Red
3
TRANSMITTER CONTROLS
