5.
ATTACHING FINS
FINS SHOULD
PROJECT STRAIGHT
FROM THE BODY.
NOTE:
FINS MUST BE ATTACHED CORRECTLY FOR A STABLE FLIGHT.
90˚
90˚
90˚
90˚
FIN
FIN
FIN LINE
FIN LINE
FIN
FIN
A.
Apply thin layer of glue to edge of Fin, wait one minute. Apply second
layer and attach Fin to Body Tube along one of the Fin lines. Repeat
for remaining Fins.
B.
Check alignment of Fins
as shown. Allow glue to
set.
C.
Stand rocket on flat table until
glue dries completely.
A.
Scrape excess flash from
Nose Cone and clean the
eyelet of the Nose Cone.
B.
7.
ATTACHING PARACHUTE & SHOCK CORD
DOUBLE
KNOT
SHOCK
CORD
C.
D.
E.
8.
ATTACHING LAUNCH LUG
A.
Glue Launch Lug centered
onto “LL” line where shown.
B.
Apply glue fillets along
Launch Lug and Fin/Body
Tube joints, smoothing each
fillet with your finger. Let
glue dry completely.
6.
ATTACHING SHOCK CORD
A.
Cut out Shock Cord
Mount from Tube
Marking Guide.
B
.
Apply glue. Fold
forward.
D.
Squeeze tightly
and hold for one
minute.
E.
Glue mount 1” (25 mm) inside Body Tube.
Hold until glue sets. Let glue dry completely.
LA
UN
CH
L
UG
FIN
#
2
FIN
#
1
FIN
#
4
EN
G
IN
E H
O
O
K
FIN
#
3
SHOCK CORD
PAINT SCHEME
First spray rocket with white primer, let dry and sand. Repeat until rocket is smooth. Follow the paint scheme on the front
panel or design your own.
Peel decals from backing sheet and apply where
shown. Rub down to remove bubbles.
* OPTIONAL - Clear Coat entire rocket when complete.
page 3
C
.
Apply glue. Fold
forward.
G
LU
E
EYELET
CAUTION: Do not cut off
eyelet of Nose Cone.
WHITE 1/32” (1 mm) PIN
STRIPE OR PAINT PEN
DECAL
BLACK
WHITE
BLACK
WHITE
BLACK
1”
(25 mm)
3
G
LU
E
3
2
1
G
LU
E
BLACK
LL
2 1/2”
(64 mm)
