ESTES® INDUSTRIES
1295 H Street
Penrose, CO 81240
PRINTED IN CHINA
www.estesrockets.com
PARTS:
Locate the parts shown below and lay them out on the table in
front of you. DO NOT USE THIS DRAWING TO ASSEMBLE
YOUR ROCKET.
ASSEMBLY TIP
Read all instructions before beginning work on your model.
Make sure you have all parts and supplies.
TEST-FIT ALL PARTS TOGETHER BEFORE APPLYING ANY
GLUE. If any parts don’t fit properly, sand as required for
precision assembly.
KEEP FOR FUTURE REFERENCE.
HELPFUL HINT: IF NOSE CONE/COUPLER FIT IS. . .
TOO
TIGHT
TOO
LOOSE
ADD
MASKING TAPE.
SAND FOR FIT.
Blue Engine
Mount Tube (1)
(30326-1)
Launch Lug (1)
(38175)
Decal Sheet (1)
(37713)
Assembled 12” (30 cm) Parachute
(35801)
Engine Hook (1)
(35021)
Shock Cord (1)
(38374)
SUPPLIES
In addition to the parts included in the kit you will also need:
Body Tube BT-60 (1)
(30400)
Centering Ring Card
RA-2060 (1) (30128)
(01/02) P/N 37713
Die Cut Balsa Sheet (1)
(32393)
TUBE MARKING GUIDE AND SHOCK CORD MOUNT
LAUNCH LUG
FIN
FIN
FIN
FIN
MATCH
LINES
MATCH
LINES
Nose Cone (1)
(71020)
Green Engine
Block (1)
(30162-2)
Mylar Retainer
Ring (1)
(30168)
OR
SCISSORS
PENCIL
RULER
FINE
SAND PAPER
(#400-600 GRIT)
CARPENTER’S
GLUE
MODELING
KNIFE
MASKING
TAPE
PRIMER
(WHITE)
SPRAY PAINT:
BLACK & WHITE
SPRAY CLEAR
COAT
(OPTIONAL)
1/32” (1 mm)
WHITE
PIN STRIPE TAPE
WHITE PAINT
PEN
TM
FLYING MODEL ROCKET KIT INSTRUCTIONS
EST 1261
