Estelon Extreme, User Manual, Page: 9 / 20

EXTREME USER MANUAL 9
Continue with unpacking and assembling the Upper Module:
Upper Module A must be assembled with Lower Module A, and Upper Module B must be
assembled with Lower Module B (please see serial number/product code).
11. Unlock / Open all four locks on the flight case cover. This should only be done with
the speaker / flight case in a horizontal position.
12. Carefully lift the cover off the flight case and put it aside.
13. Do not touch drivers – note the warning stickers.
14. Remove the softening pillow (#10) from the flight case and put it on the floor
(approx. 1 meter from the Lower Module).
15. Now, supporting the speaker with one hand and holding the belt # 11 with the
second hand, take the speaker out of the flight case and place the lower part on the
softening pillow as shown in the drawing. This procedure must be carried out by two
strong persons – one on each side of the speaker.
16. Find the balance so it is easier to hold the speaker in a vertical position. The third
person should open the velcro on the back of the cloth bag. Now, while third person
supports the speaker, and the other two people take the belt #12 (still holding the
belt #11).
17. Please position the rear part of the Upper Module facing the front part of the Lower
Module (you may need to lift the speaker for turning it). Raise the speaker for approx.
30 cm from the pillow and adjoin with the Lower Module as shown in the drawing;
third person must support the Lower Module and protect it from moving (remember,
it is on cart).
18. Slowly, lower the Upper Module until the two cones are (#13) strongly fixed in
the grooves (#14).
19. Remove belt # 12.
20. Remove protective matte from the top of the Lower Module.
21. Remove cloth bag from Upper Module.
22. Please repeat procedure 11-21 with the second Upper Module.