ESTELLE ESMPRHRDRYA, User Manual

Page: 4 / 12

•
When unplugging the power plug, do not pull the power cord; always pull it out by
holding the power plug.
• Fully insert the power plug. Please use the socket alone; do not use a power
terminal block.
•
When the hair dryer blows hot air, if you see sparks at the air outlet, please stop
using it and remove the dust attached to the outlet and the air outlet
• After use, please be sure to set the power switch to the [0] position and pull out the
power plug from the socket
•
This product must be installed and fixed in a place that cannot be touched during
bathing
• To protect your safety, it is recommended to install a leakage protection device
(RCD) with a rated leakage action current not exceeding 30 mA in the electrical
circuit of the bathroom power supply and consult the RCD installer
• If the power cord is damaged, to avoid danger, it must be replaced by kogan.com.
• Properly dispose of the packaging bag and power plug protection of this product to
keep it away from babies.
•
This product is not suitable for use by persons with physical, sensory, or mental
disabilities or persons who lack experience and knowledge (including children). A
guardian must supervise and guide the use of this product and be responsible for
the safety of the user.
• Avoid dropping the hair dryer or subjecting the hair dryer to strong shocks, which
can cause electric shock or fire.
•
During use, the air outlet and nozzle may become hot, please do not touch it with
your hands.
• Do not use it when the air inlet is damaged.
• Do not use on babies.
• Please use it only for blow-drying and styling. Do not use it for pets or blow-drying
clothing.
•
Please keep more than 10 cm between the air inlet and your hair.
•
Please keep more than 6cm between the air outlet and the hair.
This hair dryer comes with an overheating protection device, which can automatically
switch to cold air when the temperature of the hair dryer is too high.
When this occurs, it is recommended to immediately turn off the power switch and unplug
the plug from the power socket, let it cool down for a few minutes before using it. Check
that there is no thread or hair at the air inlet and outlet and then turn on the power switch.