5
SPEED INDICTOR BAR:
The speed indicator bar displays which speed (1-5) the mixer
is currently set to . If the mixer senses that there is an uneven load in the mixer bowl, a
notification will flash on the display .
DIGITAL DISPLAY:
The digital displays are divided into two sections . The left single-
digit display is the program display area, which is used to display the current set program
number . The right two-digit display is the time display, which is used to show the time in
minutes, or in seconds if the timer is less than 1 minute . If the time is shown in minutes,
a dot on the timer display will flash to signify that it is still counting . If a program is not
selected and the timer is not set, it will count up from 0 and the program display will show
0 . If the timer is above 99, the program display will show "-", indicating a countdown .
If a program is selected the program display area will display the current program number
(1-6) and the time display area will display the remaining time that corresponds to the
specific program . The timer will always count down based on the program that is selected .
BUTTONS:
The buttons on the control panel
are as follows:
Start/Pause
– Begins or pauses the mixer’s
motor
Stop
– Stops the mixer’s motor
Timer Up Arrow
– Increases the amount of
time on the timer
Timer Down Arrow
– Decreases the amount
of time on the timer
Speed Up Arrow
– Increases the speed of the motor
Speed Down Arrow
– Decreases the speed of the motor
Programs
– Used to create or select from preset programs
Program Selection Numbers (1-6)
– Chooses the program that corresponds to the
respective program number
CONTROLS
NOTE:
New mixer bowls and agitators (beaters, whip, and doughhook) should be
thoroughly washed with hot water and a mild soap solution, rinsed with either a mild
soda or vinegar solution, and thoroughly rinsed with clean water BEFORE being used .
This cleaning procedure should also be followed for bowls and agitators before whipping
egg whites or whole eggs .
CONTROL PANEL
