11
CONTROL PANEL FUNCTIONS
When the heat function is used for the first time, a slight odor may be present.
This is normal and should not occur again unless the heater is not used for an
extended period of time.
NOTICE
CONTROLS
FUNCTION
Flame Button
Press Flame Button
to desired flame
color.
10 different color options.
Flame +/-
Press Flame (+/-) Button
to desired flame
brightness.
3 options. ONLY works when flame button is ON.
Fuel Bed
Press Fuel Bed Button
to desired fuel bed color.
(10 different color options).
Fuel Bed +/-
Press Fuel Bed (+/-) Button
to desired brightness.
3 options. Only works
when
flame button is ON.
Back Light
Press Back Light Button
to desired back light
color.
10 different color options.
Back Light
+/-
Press Back Light (+/-) Button
to desired back light
brightness. 3 options. ONLY works when Back Light button
is ON.
Flame Speed
Press Flame Speed Button
to desired
flame speed.
5 options.
Timer +/-
Press Timer (+/-) once
to
increase timer setting
by ½ hour
increments. Maximum timer setting is 7½ hours.
Indicator light
will illuminate.
Press Timer (+/-) button again to turn off timer.
Heater
Press Heater Button once, 750W (LOW HEAT)
heater turns
on and the fan starts to blow warm air.
Press Heater Button
again,
turns on
1,500W (HIGH HEAT)
heater turns on and blows
hot air.
Press Heater Button again
and the heater turns
OFF.
The fan will continue to blow to allow heater to cool down, and
then turns off.
NOTE: The Heat Enabling Switch (on the back
of the unit) must be ON for the Heater function to operate.
Thermostat
Control Knob
Heater must be ON either LOW or HIGH heat for the
thermostat function to operate.
The heat output is controlled
by the
Thermostat Control Knob.
Set the
Thermostat Control
Knob
to the maximum position initially. When the room reaches
the desired temperature, reduce the setting by slowly turning
the thermostat knob, counterclockwise until the heater will click
and turn off. The heater will then maintain the room temperature
at the desired level.
NOTE: The Heat Enabling Switch (on the
back of the unit) must be ON for the Heater function
to operate.
Main Power
ON/OFF
Press ON
. Power turns ON. All functions are enabled.
Press
OFF.
Power, flame effect, and all functions turn off.
THERMOSTAT
ON
OFF
