7
Control Panel
BUTTON
ACTION / FUNCTION
INDICATION / RESULT
ON/OFF
1. Press to turn on the flame effect
and fuel bed lights, and to enable
the control panel & remote control.
2. Press again to turn off the flame
effect, and shut off power to the
remote control, and all functions.
1. The flame effect, fuel bed, and indicator
lights turn on. The control panel & remote
control are enabled.
2. The flame effect, fuel bed, and indicator
light turn off. The control panel and remote
control will not function.
DIMMER
The DIMMER controls the
brightness of the flame effect.
The flame effect cycles through different
levels, then returns to the first level.
HEAT 1
HEAT 2
1. With the flame effect on, press
once to turn on the low heat (1).
2. Press again for high heat (2)
3. Press again to turn the heat off.
NOTE: The flame effect must be
ON for the heater to function.
1. The heater, fan, and indicator light turn
on low (1). Warm air blows
.
2. The heater turns on high (2). Hot air
blows
.
3. The heater turns off.
Fans may continue
to blow air to cool the unit down.
THERMOSTAT
Turn the knob to set the
temperature to the desired level.
NOTE: If the room temperature
is below the thermostat setting,
the heater will not turn on.
The heater will automatically turn off when
the room temperature rises above the set
temperature. The heater will automatically
turn on when the ambient room temperature
drops below the set temperature.
Remote Control Operation
NOTE: ON/OFF switch on control panel must be ON to use remote control.
BUTTON
ACTION / FUNCTION
INDICATION / RESULT
ON/OFF
1. Press once to turn on flame
effect, fuel bed lights, and enable
the remote control functions.
2. Press again to turn off the flame
effect, and shut off power to the
remote control, and all functions.
1. The flame effect, fuel bed, and indicator
lights turn on. The remote control functions
are enabled.
2. The flame effect, fuel bed, and indicator
light turn off. The remote control functions
are disabled.
DIMMER
The DIMMER controls the
brightness of the flame effect.
The flame effect cycles through different
levels, then returns to the first level.
HEAT
1. With the flame effect on, press
once to turn on the low heat (1).
2. Press again for high heat (2)
3. Press again to turn the heat off.
NOTE: The flame effect must be
ON for the heater to function.
1. The heater, fan, and indicator light turn
on low (1). Warm air blows
.
2. The heater turns on high (2). Hot air
blows
.
3. The heater turns off.
Fans may continue
to blow air to cool the unit down.
NOTICE
When the heater is first turned on, a slight odor may be present. This is normal and
should not occur again unless the heater is not used for a long period of time.