5
FLIGHT SETTING AND ADJUSTMENTS
AUTOMATIC CALIBRATION (on flat horizontal surface): (11)
ADJUSTING OF THE TRIM (FINE TUNING) (10)
Practice simulation before actual flying
1. Please practice with the RCU joysticks and buttons until you will get used to the Remote Controller.
2. Put the aircraft in the open space, 2-3 meters in front of you, the red lights mark the front of the drone.
3. Exercise the joystick functions without turning on the RCU, then practice the hovering function and adjusting
the trim of the drone first, see instructions further. Hovering means keeping the drone in the mid-air, fixed
position.
It is recommended to set the drone into “calibration” mode
before flying, so all settings will be restored as factory settings
with automatic fine-tuning.
Calibration methods :
1. For Gyroscope calibration please move simultaneously left
and right joysticks to lower right position. Wait until the LEDs on the drone stops blinking.
2. For Direction reset please move simultaneously left and right joysticks to lower left position. Wait until the LEDs
on the drone stops blinking.
It is recommended to perform both calibrations before the flight.
When starting to hover at the low level above the ground the drone may move slightly in either direction – left
or right, forward – backwards, or turn left - right even if the joysticks are in central position. If this is noticed, it is
required to proceed fine tuning by the help of fine tuning buttons on the RCU FUNCTIONS. There are 2 buttons
with 2 positions for fine tuning each direction, please check the picture of RCU. Press these buttons up to several
times (each time you will hear the beep) for forward – backward, left –right and turning right – left fine tuning.
Please check the illustrations for the trim adjustments.
360 degree FLIPPING FUNCTION (9)
When you are used to basic operation, you can do some awesome tricks and stunts!
First, fly the drone to the height not less than 2-3 meters, press FLIP button (press down RIGHT joystick) , then
push the right joystick in any desired direction to make 360 degree flip.
