EN
3
English
Installing the battery
Follow the steps below to install the battery.
Press down the edge
of the battery cover
Pull out the cover
Install the battery
Replace the cover
Push the cover down
until it is snapped well
Swing to open the
cover
Please insert the battery in the same direction as shown above.
Replace the battery with a new one when the red indicator blinks continuously.
Replace the battery according to the steps as above.
Pairing function of the 3D glasses
of the TV).
2. Press and hold the Power button on the 3D glasses over 6 seconds, the red
3.
The 3D glasses will begin to function if the pairing is completed. You will notice
the shades of the lenses changing.
Notes:
•
Ensure your TV and the 3D glasses are no farther than 1 meter apart from each
other while pairing is in process. Power off any other TVs that are located within 3
to 5 meters, or exit their 3D mode to avoid pairing the wrong 3D TV.
•
Pairing might be needed again after TV is repaired.
Operations and indications of 3D glasses
2. There are three modes: 3D mode, right eye mode and left eye mode. Refer to the
table below for mode switching:
This product
utilize
s radio frequency
(
RF
)
technology. Pairing is required when using
the 3D glasses for the first time
;
this prevent
s
two or more TVs from interference
while working at the same time. After pairing, the 3D glasses receive the 3D signal of
paired TV only. If the pairing is successful, there is no need to pair the glasses to the
TV again next time. Re-pairing is needed when another TV set is used with the 3D
glasses. Pairing steps for the first time are as below:
1.
Turn on the TV, then set the TV to 3D mode (Refer to the corresponding manual
indicator will blink if the pairing has commenced. When the pairing is successful,
the red indicator turns off. The pairing is in pro
gress
when the red indicator
blinks continuously.
•
If the pairing procedure has failed, the 3D signal might be improper or; there is no
signal from the transmitter. Recheck according to the steps as above.
is no signal
for
60 seconds.
1.
Power on/off (standby): Press the Power/mode button
;
the 3D glasses are
powered on and ready to receive signal wh
en
the red indicator blinks once.
Press and hold the button for 6 seconds to enter standby mode.
•
Complete step 1 and 2 within 60 seconds, otherwise, the 3D glasses will
enter standby mode automatically. The 3D glasses will enter standby if there
