exposure requirements, a minimum separation distance of 10mm
must be
Third-party belt-clips, holsters, and similar accessories used by this device should not
contain any metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be avoided.
Use only the supplied or an approved antenna.
This transmitter may operate with the antenna(s) documented in this filing in
Push-to-Talk and body-worn configurations. RF exposure compliance is limited to the
specific belt-clip and accessory configurations as documented in this filing and the
separation distance between user and the device or its antenna shall be at least 2.5
cm.
IC Warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
RF Exposure Information and Statement
The SAR limit of USA is 1.6 W/kg averaged over one gram of tissue. Device types: Multi Mode 4G
Android PTT Phone (IC: 26705-E966) has also been tested against this SAR limit. The highest SAR
value reported under this standard during product certification for use at the ear is 0.682W/kg
and when properly worn on the body is 0.593W/kg. This device was tested for typical body-worn
operations with the back of the handset kept 10mm from the body. To maintain compliance with
IC RF exposure requirements, use accessories that maintain a 10mm separation distance
between the user's body and the back of the handset. The use of belt clips, holsters and similar
accessories should not contain metallic components in its assembly. The use of accessories that
do not satisfy these requirements may not comply with IC RF exposure requirements, and should
be avoided. Body-worn Operation This device was tested for typical body-worn operations. To
comply with RF exposure requirements, a minimum separation distance of 10mm must be
-party
belt-clips, holsters, and similar accessories used by this device should not contain any metallic
components. Body-worn accessories that do not meet these requirements may not comply with
RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.
This transmitter may operate with the antenna(s) documented in this filing in Push-to-Talk and
body-worn configurations. RF exposure compliance is limited to the specific belt-clip and
accessory configurations as documented in this filing and the separation distance between user
and the device or its antenna shall be at least 2.5 cm.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le