MAINTENANCE
CAUTION: Turn off all electrical power to this unit before opening or attempting any service.
Occasionally inspect your cooler for leaks, loose belt, blocked water lines, correct belt
alignment or excessive residue buildup on the pads. Inspect cabinet for rust. If rust
spots appear, sand and paint with a high-grade, corrosion resistant paint.
BELT ADJUSTMENT
An improperly adjusted belt will greatly shorten motor life. A deflection of 1” with 3 to 5
pounds of force applied will indicate proper adjustment.
Do Not
use the motor pulley to
adjust belt tension. Always use the Motor Adjustment Assemblies to adjust the belt
tension.
OILING
Lube the blower bearings twice per year. Use SAE 20W or 30W, non-detergent oil on
bearings with oil cups and standard bearing grease on ball bearings. Oil the blower
motor if it is equipped with oil holes. Some motors are permanently lubricated at the
factory.
REMOVING GRILLES
Slip a small screwdriver under a stainless steel clip and pry up until clip snaps open.
Repeat for other nine clips. Ensure that grille is set in a safe place where it can not
fall and or will not be broken.
REPLACING MEDIA
1. Remove grilles.
2. Tilt top of module away from cooler and disconnect water hose.
3. Remove vertical retainers.
4. Remove polyester filter and discard.
5. Push bottom of center piece of CEL-dek out of module and remove CEL-dek.
6. Repeat for two remaining pieces of CEL-dek.
7. Install new CEL-dek and polyester filter.
8. Replace vertical supports.
Item P/N Description
1 516144
Retainer-Vertical
2 504167
Top
Support
3 523159
Top
4
512544 Water Distributor
5 524295
Grommet
6 524088
10”
CEL-dek
7 524087
12”
CEL-dek
8 523158
Side
9 523160
Bottom
10 514593
Polyester
Filter
11 504166
12 589096
Pop
rivets
13 524099
Cap
14 514028
Distributor
pad
4
60°
30°
Proper Pad
Orientation
Air
Flow
9
6
11
14
8
12
4
12
3
2
12
1
13
12
8
10
12
5
7