Essick Bemis DP3 200, Use And Care Manual

Page: 6 / 52

3) This model also features an air purification filter which rests between the
evaporative wicks and cleans the air as it provides humidity. Refer to the
CARE AND MAINTENANCE section for instructions on installing and
removing the air purification filter.
4) Remove a water bottle, observe the water
bottle cap (A), and locate the valve stem mechanism (B).
The cap may be removed for filling and to provide easy
access for cleaning with a long soft brush. The valve
supplies a regulated amount of water to the water chan-
nel and wick. Do not attempt to increase water flow by
modifying this valve or adding additional holes to the
bottle. Doing so will invalidate your warranty and may
cause water damage to your home. NOTE: The water
level can easily be observed through the tinted water
bottle. It is time to refill the bottle when there is an inch
or less of water remaining in the water bottle.
5) Take the water bottles to a sink, laundry basin, or bath tub. Use care in
handling the water bottles. Do not drop the bottles. They will break. Turn
bottle upside down and remove screw cap. Empty any remaining water
in bottle, rinse the bottle thoroughly, and wipe outside clean with a cloth
before adding fresh water.
6) To add water, place a soft cloth
in sink and place the bottle on it.
Turn on the cold water tap and
steady the bottle while filling. Each
bottle holds 1.6 gallons. Do not over
fill. When full, replace the screw
cap and tighten securely. Place the
bottle carefully on a protected flat
surface and wipe it dry with a soft
cloth.
7) Return the bottle to its upright
position using the handle on the top
of the bottle. Slowly set the bottle in
the recessed area, the top of the bot-
tle flush with the top of the 2 in 1 air
purifier & humidifier.
8) When positioned properly, the
valve will open and water will flow
into the water channel. The water
level will automatically remain at the
height of the pin in the water channel until water bottle is empty.
A
B