RII115-‐C-‐210421.docx Copyright© 2020 Essex Electronics, Inc. All Rights Reserved
Mounting
HEW-‐1
is designed for narrow or mullion mount applications. For recessed installation, use template provided to mark and
remove material. For surface mount installation, an optional spacer ring (SR-‐1) is available.
HEW-‐2
is designed to mount to a standard U.S. Single Gang switchbox. An optional extension back box (BAK BOX-‐SGE) is
available for surface mount installation.
HEW-‐3
is designed to mount to a standard U.S. Double Gang switch box.
An optional extension back box (BAK BOX-‐DGE) is
available for surface mount installation.
TYPICAL INSTALLATIONS
There are two sets of relay contacts that may be used. The normally closed
contacts, the white wire to the yellow wire, would be in series with a normally
powered locking mechanism, such as a magnetic door lock. This would also be in
series with the controller applying locking power. The normally open contacts, the
orange to the blue wires, could be used to apply a “request to exit” or “REX” signal
to the controller, which would then apply power to unlock. Since both sets of
contacts are not normally used at the same installation, the set that is not being
used as described may be used to indicate that the HEW has been activated, to a
control panel or security system.
Regulatory Compliance -‐ FCC
End Product Labeling
The next assembly should have instructions and a label that refers to the manufacturer FCC ID: UXS-‐IPM165 & Canada IC: 6902A-‐IPM165 for all models of the Hand-‐E-‐Wave.
This device HEW has been tested and approved to be compliant with Part 15.245 of the FCC Rules and with RSS-‐210 Issue 7 of Industry Canada. Operation is subject to the following
conditions:
1.
This device may not cause harmful interferences, and
2.
This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is
encouraged to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or and experienced radio/TV technician for help
This device has been tested and approved to comply with Part 15B unintentional radiator requirements. The antenna of the module may not be removed, replaced nor modified.
The antenna must not be co-‐located or operating in conjunction with any other antenna or transmitter. No additional antenna must be used.
This device may not cause harmful
interferences, and this device must accept any interference received, including interference that may cause undesired operation.
WARNING
: CHANGES OR MODIFICATIONS TO THIS EQUIPMENT NOT EXPRESSLY APPROVED BY ESSEX MAY VOID THE FCC AUTHORIZATION
TO OPERATE THIS EQUIPMENT.
Patents Pending
Hand-‐E-‐Wave™ is a trademark of Essex Electronics, Inc
