Section 3 -
LED SETTINGS
The LED’s can be set to a variety of outputs as noted below. To change LED settings, simply press and hold the program
button #1 on the back of the Hand-E-Tap for 5 seconds until you hear 3 beeps indicating you are at the “0” setting. Release
button and press the desired number of times for the corresponding setting. When finished, wait 5 seconds and the Hand-
E-Tap will beep 3 times confirming the settings have been successfully programmed.
0 presses – Normally Off – Both LED’s continuously lit while relay active.
1- Normally Off, will flash On once with Hand-E-Tap button press
2- Normally Off, will flash both LED's while active
3- Normally Off, will flash LED's alternately while active (default)
4- Normally On, will flash Off once with Hand-E-Tap button press
5- Normally On ,will flash Both LED's while active
6- Normally On, will flash LED's alternately while active
7- Left LED Normally On, right LED On while active
8- Right LED Normally On, left LED On while active
9- LED's controlled externally
Section 4 -
AUDIO BEEPER SETTINGS
To change the audio beeper settings, press and hold the program button #2 on the back of the Hand-E-Tap for 5 seconds
until you hear 3 beeps indicating you are at the “0” setting. Release button and press the desired number of times for the
corresponding setting. When finished, wait 5 seconds and the Hand-E-Tap will beep 3 times confirming the settings have
been successfully programmed.
0 presses - No Beeps
1- Beep once with Hand-E-Tap button press
2- Beep at 1 second interval while active (default)
3- No beeps - Finder Beep activated (10 sec interval)
4- Beep once with Hand-E-Tap button press plus Finder Beep (10 sec interval)
5- Beep at 1 second interval while active plus Finder Beep (10 sec interval)
FINDER MODE AUDIO SETTINGS
If the audio beep settings; 3, 4 or 5 was selected above, you can change the audio level of the “finder beep”. Press program
buttons 1 and 2 at the same time. A double beep indicates they are both pressed. Hold for 5 seconds to enter programming
mode (3 beeps) then release.
Press button 1 for longer (louder) beep
Press button 2 for medium finder beep
Press button 3 for short (quieter) beep (default setting when finder beep is enabled)
