using the device
24
V.1.0
using the device
25
V.1.0
Listening to radio
1.
Briefly press the button
FM
to turn the radio on.
2.
Adjust the volume using the buttons and .
3.
Briefly press the button
to perform an automatic scan. It stops when a
radio station has been found.
4.
To search manually, press and hold down the button
while pressing the
buttons
and . With each press, the frequency decreases or increases
by 0.10 MHz.
5.
Extend the antenna wire for better FM reception.
6.
To turn off the radio, briefly press the button
FM
.
Setting the “Sleep” function
This radio alarm clock has a delayed sleep function. The radio automatically turns
off after a preset time between 90 minutes and 10 minutes.
1.
Select a radio station and the desired volume level to fall asleep.
2.
Briefly press the button
.
The default sleep time is 10 minutes.
3.
To select the auto sleep timer, press the button
several times until the
desired standby time is reached: 10 min, 15 min, 30 min, 60 min, or 90 min.
4.
To cancel the sleep mode and turn off the radio, press repeatedly on the button
until the display reads
OFF
and the radio turns off.
Setting the time
1.
Press and hold the button
for 3 seconds. The hour will flash.
2.
Use the buttons and to set the hour, then press the button
. The
minutes will flash.
3.
Use the buttons and to set the minutes, then press and hold the
button
, or wait a few seconds. The time is set when the digits stop
flashing.
Projecting the time on the ceiling
The projection of the time on a ceiling or wall should be done in a dark room. The
maximum projection distance is 2 meters.
1.
Take the projector out of its compartment and point it in the desired direction.
2.
To project the time temporarily, press the switch on the top of the projector
once. The projection stops automatically after 10 minutes.
3.
To project the time permanently, press the switch twice quickly. Press the
switch again to turn off the projector.
4.
Turn the focus knob to adjust the sharpness of the projected image.
Setting the alarm
1.
Press and hold the button
for 3 seconds. The hour will flash.
2.
Use the buttons and to set the hour, then press the button
. The
minutes will flash.
3.
Use the buttons and to set the minutes, then press the button
. The
white indicator light will flash.
4.
Select the wake-up mode of your choice (radio
or buzzer
) by
pressing again the button
.
5.
Next, press and hold the button
, or wait a few seconds. The alarm
setting is saved when the digits flash once and then disappear to make way
for the time. The alarm activation indicator light appears on the display to
the left of the time.
Snooze:
When the alarm sounds, press the
Snooze/Dimmer
button. The buzzer or radio
stops and then resumes after 9 minutes.
Summary of Contents for RRVP-100
Page 29: ......
