P2601 OVERBED TABLE
1. Invert Table Top (1). Slip the Angle Adjusting Screw
Assembling (4, 5, 6) of the Table Mounting Arm (3) into
the Table Mount Bracket (2) as shown and tighten the
Angle Adjusting Knob (6) slightly.
2. Slip the arm of the Table Support (8) over the arm of the
Table Mounting Arm (3) and secure it slightly with the
Height Adjusting Knob (7).
3. Install Caster Support Arms (9) into horizontal arm of the
Table Support (8), using M8 Socket Head Cap Screws
(11) and Steel Washers (12) and #6 Allen Wrench (13).
4. Install all four Casters (10) into the Caster Support
Arms (9) by pressing them into each hole of the Caster
Support Arm (9) until secured in position.
5. Turn the Table assembly right side up and adjust as
needed.
6. To adjust the Table Top (1) to desired height, lift the table
and when in position, secure it with the Height Adjusting
Knob (7).
7. To adjust the angle of the Table Top (10 , loosen the
Angle Adjusting Knob (6) and turn the Table Top(1) to
desired position. Tighten the Angle Adjusting Knob (6)
when done.
2011 Essential Medical Supply, Inc.
®
The Casters with Locks (10) shall be in locked position
before using the Table.
ASSEMBLY INSTRUCTIONS
CAUTION
