9/28/2007
VoIP Phone Administration Guide
MAG-07005-2 Rev. D
1 Introduction
This administration guide is for EIP 7012. The administration guide explains the keypad instruction,
web configuration and command line configuration for VoIP Phone. Before using VoIP Phone, some
setup processes are required to make the VoIP Phone work properly. Please refer to the Setup Menu
for further information.
1.1 Harware Overview
EIP 7012 has the following interfaces for Networking, telephone interface, LED indication, and power
connector. EIP 7012P supports POE that can connect to POE switch and use the power of POE
switch.
Two RJ-45 Networking interface, these two interfaces support 10/100Mps Fast Ethernet. You can
connect one RJ-45 Fast Ethernet port to the ADSL or Switch, and connect the other one to your
computer.
LED Indication: some LED indicators in the VoIP Phone show the functions, like speaker phone,
Register, and so on.
Dimension: approximately 18 x 20 x 8 cm
Weight: approximately 220g
Operating temperature: 0-50°C
Adapter: Input:100-240V, 50-60Hz
Output via general adapter: 6V, 1A
Output via Power over Ethernet on WAN port: Typical 5V, 1.2A (7012P only)
FCC Class B
CE, 89/336/EEC
LVD: 73/23/EEC
RoHS compliant
Warning:
AC Input out of defined range will cause phone malfunction or damage!
1.2 Software Overview
Network Interface
․
Two RJ45 10/100 Base-T
Ethernet ports
Display
․
16 characters x 2 lines
․
Backlit, grayscale
SIP
․
SIP v2 (RFC 3261)
․
SIP RPORT(RFC 3581)
1
