Installing Special Equipment
Care@Home™ Passive Infrared Detector User Guide
15
Figure 12: PIR: The Tabs of the Front Panel and Back Cover
4.1.2
Closing the PIR
To close the PIR, perform the following procedure:
1.
Insert the tabs, at the bottom end of the front panel, into the inner square slots, at the bottom end
of the back cover, as illustrated in Figure 13 below.
Figure 13: Align and Insert Tabs in Square Slots
2.
Position the top of the back cover onto the top of the front cover, while aligning the latch tab
under the lock tab of the front panel, as shown in Figure 11 on page 14.
3.
Holding the PIR with the back cover facing you and both thumbs on the holes for the screws, press
the back cover into the front panel until the latch tab clicks under the lock tab of the front panel.
Alternatively, using a flat screwdriver, press downward on the back cover latch-tab until the latch
tab clicks under the lock tab of the front panel.
4.
Screw-in the two screws, if screws are required.
5.
Insert the battery, as required.
Front Panel Lock Tab
Back Cover Latch Tab
