Handle:
Advances
items through the
machine when turned
clockwise.
The Built-in Grip/Carry Handle:
Take your machine almost
anywhere.
The Input Tray:
Used to feed
items into tray.
Patented Easy Loading Cartridge:
Allows you to change from adhesive
to laminate to magnet in just seconds.
Removable Cutter:
Gives you
the freedom to trim your document
both in and out of the machine. Use
it for anything you need to take the
edge off!
Step One
Place item on feed tray.
Step Two
Guide item forward while slowly
turning knob clockwise until your
item comes out of the back of the
machine.
1.
Open cartridge
compartment by lifting up
on latch.
Unloading
Loading
2.
Gently pull cartridge up
and out of machine.
1.
Open lid. Slide cartridge into
tracks on machine sides with
exposed rolls of material facing
open lid cover. Close lid securely.
Advance film and trim.
1.
Align cut tray sides with
the machine. Slide in the cut tray
with the cut bar resting on the
spring arms on the side of the
machine until it snaps and locks
into place.
Cut Tray
Cut Blade
1.
Loosen and remove the screw
in the cut bar with wrench. Remove
colored plastic insert and slide the
old blade off cut bar (safely discard
old blade).
2.
Carefully slide new blade
onto cut bar. Note: Sharp
edge of blade should be
facing inward. Replace the
colored plastic insert and
secure with wrench.
Unloading & Loading
Replace the Cut Tray & Cut Blade
Basic Operation as easy as 1-2-3!
• For best results, turn the handle slowly.
• Burnish or rub around your adhesive items well before removing the top film.
• Arrange small items (without overlapping them) on the feed tray to maximize your cartridge
material use.
• Use items that are .10” thickness or less.
• If there is excess adhesive around edges of an item, simply wipe off with your fingers.
• Fabric Tips:
- Works well with most fabrics that do not have sizing
- For items that will be washed, stitch after adhering
- For best results, use Acid-Free Permanent Adhesive
• If machine rollers pick up adhesive after use, clean with isopropanol alcohol.
• Store your machine and cartridge between 40ºF and 70ºF
• To prevent curling on adhesive, remove the clear top mask first. Then lay your your document
upside down to remove the backing from the sticky side.
• Great to apply adhesive to your document before cutting on the Xyron
®
Wishblade
®
.
Visit
www.xyron.com
for more information.
Helpful Hints
Features & Functions
Step Three
Press down on cut blade and slide
to the left or right to cut.
Note: For a smooth cut, place your
finger all the way back to the back
of the cut blade holder. Remember
to burnish or rub well on adhesive
items before removing film.
All manuals and user guides at all-guides.com
