Esscom PL-1220, Installation Manual

Page: 35 / 50

PL-1220
35
E
N
GL
IS
H
7 Adding an additional PL-1220
A Powerline network can be created with up to a maximum of eight
Powerlines. If you already have two Powerlines in operation, you can
add a maximum of six.
To add a Powerline, follow the procedure set out below.
1. Plug the extra Powerline into the power socket.
2. Push down for two seconds on the key on one of the Powerline plugs
that is already in operation.
The on/off light will flash slowly (0.5 seconds on/0.5 seconds off).
3. Within two minutes, push down the key on the extra Powerline plug
for two seconds.
The connection sequence starts.
Once the connection is complete, restart the plugs and the Powerline
LEDs on both plugs will light up.
Push down the reset/simple connect key for at least
12 seconds to restore the PL-1220 factory settings.
When the factory settings are restored, the PL-1220
plug will need to be reconnected!
Before adding the new Powerline, it is recommended that
the network passport for this plug be changed by pushing
down the "reset/simple connect" button for 12 seconds.
A Powerline that has already been used in another
network will still have the password for that network,
which means that the "reset/simple connect" button
mechanism will not operate.