15
User’s Manual
7.0 Trouble Display
When a trouble condition occurs, the
[
TRBL
]
key on
your keypad illuminates and if programmed by your
installer, the keypad sounder will beep. Pressing the
[
TRBL
]
key will cause it to flash, indicating that your
panel is in
“trouble display”
mode. Keys that
illuminate in
“trouble display”
mode tell you which
trouble conditions are taking place and/or are in
memory. Only the troubles that are relevant to you are
listed below. If a trouble appears and it is not listed
below, call your monitoring station to come service
your system.
Trouble conditions will remain in memory. Pressing
on the
[2
ND
]
key displays current trouble conditions.
Pressing
[
CLEAR
]
will erase trouble conditions in
memory.
Key [1] - No battery/low battery
If battery is not connected to the control panel, or if it
is at low capacity, key
[1]
illuminates. This means that
the battery connected to the panel should be replaced
because it can no longer provide adequate back-up
current in the event of a power failure.
Key [3] - AC power failure
If AC power is not being supplied to the control panel,
key
[3]
will illuminate. AC trouble can be excluded
from keypad “trouble display” by your alarm installer.
Key [4] - Bell disconnect
If a bell or siren is not connected to the bell/siren
K6X6-EU11.fm Page 15 Tuesday, January 18, 2005 2:12 PM
