3
Installation
It is highly recommended that a screened cable
is used to connect the RS485 control wires
from PTZ controller, or interference may occur.
1. Connect Ta to the RS485+ on the PTZ camera(s)
2. Connect Tb to the RS485- on the PTZ camera(s)
3. Connect GND to the ground on the PTZ camera(s) if applicable
4. Connect the cable screen to GND
5. Set camera protocol(s) and baud rate(s)
KEYBOARD OVERVIEW
Button(s)
Function
Define a preset camera position
Record new movement pattern (will directly mimic user input)
Set up a patrol route based on preset camera positions
(positions must be defined by the user)
Turn auxiliary PTZ controllers on or off
Select PTZ camera ID
(select a PTZ ID to control the associated camera)
Recall preset position
Recall pattern
Recall patrol
Set camera to auto pan mode (perimeter scan)
Adjust camera focus
Adjust camera zoom
Close/open camera iris (for non-auto iris cameras)
Menu/Esc button for navigating setup menu & key lock
Show protocol and baud rate for current PTZ ID
PTZCON Manual_Layout 2 18/03/2014 09:26 Page 3
